Aggiusta le tue cose Community Store

更換iPad Mini 3 Wi-Fi電池組

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Cinese
Passo precedente Passo successivo

Traduzione in corso passo 2

Passo 2
iPad Mini 3 Wi-Fi Battery Replacement: passo 0, immagine 1 di 2 iPad Mini 3 Wi-Fi Battery Replacement: passo 0, immagine 2 di 2

  • Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.

  • Flip the iPad back over and insert a plastic card under the battery cell nearest the logic board and right speaker.

  • If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

在以下過程中，您將在iPad的電池和後蓋之間滑動薄塑料卡，以分離將電池固定到位的膠粘劑。 小心保持卡片盡可能平坦，以避免彎曲電池，這可能會損壞電池，並釋放出危險的化學物質。

將iPad重新翻過來，並將塑料卡插入距離邏輯板和右揚聲器最近的電池下。

如果遇到明顯的阻力，重新加熱iOpener並重複上一步，使粘合劑有更多的時間軟化。

-[* icon_caution] Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
+[* icon_caution] Throughout the following procedure, you'll be sliding thin [product|IF145-101|plastic card]s between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
[* black] Flip the iPad back over and insert a plastic card under the battery cell nearest the logic board and right speaker.
[* icon_note] If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.