Aggiusta le tue cose Community Store

MacBook Pro 15" Unibody Late 2008 and Early 2009 Front Display Glass Replacement

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 9le guide che includono questo passo.

Torna alla Guida
Inglese
Italiano
Passo successivo

Traduzione in corso passo 1

Passo 1
MacBook Pro 15" Unibody Late 2008 and Early 2009 Front Display Glass Replacement: passo 0, immagine 1 di 2 MacBook Pro 15" Unibody Late 2008 and Early 2009 Front Display Glass Replacement: passo 0, immagine 2 di 2

  • In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass panel to the display. The area the adhesive is applied to is shown in red in the second picture.

  • Before starting, be sure to clean the display glass with lint-free cloth moistened with a mild solution; it will make the suction cup adhere better, and will make checking for dust on reassembly easier

  • With the heat gun set to low, start by heating the outer black border near the upper right corner of the glass panel.

  • Always aim the heat gun away from the soft rubber strip around the display glass. Heating the rubber will cause it to melt slightly, turning its finish from matte to glossy. Touching overheated rubber can cause it to permanently deform.

  • Due to the heat applied, it is normal for a layer of condensation to develop on the inside of the glass panel and/or the outside of the LCD. It can be removed with glass cleaner once the glass is separated from the display.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.