Salta al contenuto principale

iPad Mini 3 Wi-Fi LCDシールドプレート交換

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 8

Passo 8
iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: passo 0, immagine 1 di 3 iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: passo 0, immagine 2 di 3 iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: passo 0, immagine 3 di 3
  • Take the first pick you inserted and slide it up toward the top corner of the iPad.

  • If you can see the tip of the opening pick through the front glass, don't panic—just pull the pick out a little bit. Most likely, everything will be fine, but try to avoid this as it may deposit adhesive on the front of the LCD that is difficult to clean off.

1番最初に差し込んだピックを、iPadの上部端に向かってスライドして動かします。

フロントガラス越しにピックの先端が見えても焦らないでください。この場合、ピックを少しだけ外側へ戻して下さい。問題ない場合がほとんどですが、奥まで差し込みすぎないように注意してください。液晶ディスプレイ上に接着剤が付いてしまった場合、取り除くのが難しくなります。。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.