Aggiusta la tua roba

Diritto alla Riparazione

Store

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte le 18guide che includono questo passo.

Torna alla Guida
Inglese
Cinese
Passaggio precedente

Traduzione in corso passo 3

Passo 3
Use the clear plastic pull tab to gently lift the battery out of the iPhone. If the tab breaks before the battery is freed, carefully slide a spudger under the battery tab to release the adhesive. Prying in other places may cause damage. If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.

  • Use the clear plastic pull tab to gently lift the battery out of the iPhone.

  • If the tab breaks before the battery is freed, carefully slide a spudger under the battery tab to release the adhesive. Prying in other places may cause damage.

  • If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.

  • Before reconnecting the battery connector, be sure the contact clip (shown in red) is properly positioned next to the battery connector.

  • Before reassembly, clean metal-to-metal contact points with a de-greaser such as windex. The oils from your fingers have the potential to cause wireless interference issues.

  • Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

用塑料拉手轻轻将电池从机身中拉出。

如果在电池拉出前塑料拉手坏了，沿着塑料拉手方向小心的用手机撬棒在电池背部滑动几下除去胶条。在别的部位可能会造成损坏。

如果你的更换电池采用塑料套管，请在安装前将其从带状电缆中拉出来将其取下。

在扣电池座以前，确保排线接口与电池座位置相符（图中红色区域所示）。

在重新安装电池之前，先对金属接口机油进行处理比如清洁剂。手指上的油脂是潜在的危险对于无线链接模块。

进行强制重启在安装完成后，可以有效的避免一些错乱的状况。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.