Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Spagnolo

Traduzione in corso passo 1

Passo 1
Remove the following screws securing the logic board to the rear case:
  • Remove the following screws securing the logic board to the rear case:

  • Two 2.4 mm standoff screws

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  • One 2.1 mm Phillips #00 screw

Remueve los siguientes tornillos que sujetan la placa lógica a la caja trasera.

Dos tornillos separadores de 2.4 mm

Los tornillos separadores se remueven mejor utilizando una punta de destornillador de tornillo separadores de iPhone y una manga de destornillador.

Si no hay otra opción, un pequeño destornillados de cabeza plana podrá realizar el trabajo, pero usa precaución extrema para asegurarte que no se resbale y dañe los componentes circundantes.

Un tornillo Phillips #00 de 2.1 mm

[* black] Remove the following screws securing the logic board to the rear case:
[* red] Two 2.4 mm standoff screws
- [* icon_note] Standoff screws are best removed using an [product|IF145-343|new_window=true] and [product|IF145-326|driver handle|new_window=true].
+ [* icon_note] Standoff screws are best removed using a [product|IF145-388-4|standoff screwdriver|new_window=true] or bit.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* orange] One 2.1 mm Phillips #00 screw

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.