Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 3

Passo 3
Use the flat end of a spudger or a fingernail to carefully pop the two digitizer cable connectors straight up from their sockets. To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board. To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board.
  • Use the flat end of a spudger or a fingernail to carefully pop the two digitizer cable connectors straight up from their sockets.

  • To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board.

スパッジャーの平面側先端や指の爪を使って、2本のデジタイザーケーブルコネクターを、ソケットからまっすぐ引き上げます。

iPadにダメージを与えないようにするには、コネクターのみに接触してください。ロジックボード上のソケットには触らないでください。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.