Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 10

Passo 10
Once the new screen and its cables are securely in place, attach the three cables to their corresponding ports. For each cable, place the connector on top of the port and align the two as close as possible. To connect the power cable, use your finger to push downward on the middle of the connector until it snaps into place.
  • Once the new screen and its cables are securely in place, attach the three cables to their corresponding ports.

  • For each cable, place the connector on top of the port and align the two as close as possible.

  • To connect the power cable, use your finger to push downward on the middle of the connector until it snaps into place.

  • To connect each display cable, use the flat end of a spudger to press on the top of the silver connector until it snaps into place.

  • Snapping the connectors into place does require a little bit of force, but be careful, too much force can break the motherboard. If the connector doesn't snap into place with a moderate amount of force, realign it and try again.

  • Make sure the two display cables are connected to the correct ports. The grey cable should connect closest to the screen.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.