Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 8

Passo 8
Turn the driveshaft 180degrees and use a tool that will fit inside the bearing hole of the drive shaft Strike the tool with a hammer. This will move the U-joint and yoke further out of the drive shaft It should only take 2-3 hammer strikes to move the yoke and U-joint out of the driveshaft bearing holes. The bearing cup most likely will may simply fall out.
  • Turn the driveshaft 180degrees and use a tool that will fit inside the bearing hole of the drive shaft

  • Strike the tool with a hammer. This will move the U-joint and yoke further out of the drive shaft

  • It should only take 2-3 hammer strikes to move the yoke and U-joint out of the driveshaft bearing holes. The bearing cup most likely will may simply fall out.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.