Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte le 16guide che includono questo passo.
Traduzione in corso passo 3
Passo 3
-
Peeling up yellow tape as necessary, remove the following 8 screws:
-
One 4.5 mm Phillips on the right side of the heat sink.
-
Three 6 mm Phillips near the display.
-
Two large 7.5 mm Phillips with springs (don't forget to remove the springs). If the springs are not releasing, needle nose pliers can help get this done.
-
Two 13 mm screws from the left side of the heat sink and the right side of the fan.
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.