Salta al contenuto principale
Inglese
Francese

Traduzione in corso passo 10

Passo 10
Join both white cable wires and solder them together. Remember that the white wire from the AC adapter NEEDS to be soldered to the white wire from the cable that comes from the MacBook connector. The black insulated cover tube on the cable is to isolate the cable later, you can use heat to shrink it.
  • Join both white cable wires and solder them together.

  • Remember that the white wire from the AC adapter NEEDS to be soldered to the white wire from the cable that comes from the MacBook connector.

  • The black insulated cover tube on the cable is to isolate the cable later, you can use heat to shrink it.

  • The last pic shows the black insulated cover tube, you can cut it up to fit the length you need.

  • It is very important to isolate both wires, they cannot touch each other or else they will short circuit (in other words: Kaboom!).

Mettez bout à bout les deux fils blancs et soudez-les ensemble.

Le fil blanc qui vient du chargeur doit IMPÉRATIVEMENT être soudé au câble blanc qui vient du connecteur du Macbook.

La gaine thermorétractable permettra plus tard d'isoler le câble. Rétractez-la avec de la chaleur.

La dernière photo montre la gaine isolante noire. Vous pouvez la couper à la longueur que vous voulez.

Il est capital d'isoler les deux fils. S'ils se touchent, cela crée un court-circuit (autrement dit : BOOOM !)

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.