Salta al contenuto principale
Inglese
Francese

Traduzione in corso passo 4

Passo 4
With a flat headed screwdriver start separating both plastic faces from the charger. You need to use a little force to do this. Once you have separated all sides with the screw driver, it still wont come off. This thing is glued to all sides of the plastic. Insert the screwdriver into the top part of the charger and carefully separate the foil from the plastic enclosure. Be careful as to not rip off the foil from the inner part of the charger.
  • With a flat headed screwdriver start separating both plastic faces from the charger. You need to use a little force to do this.

  • Once you have separated all sides with the screw driver, it still wont come off. This thing is glued to all sides of the plastic.

  • Insert the screwdriver into the top part of the charger and carefully separate the foil from the plastic enclosure. Be careful as to not rip off the foil from the inner part of the charger.

À l'aide d'un tournevis plat, commencez à séparer les deux moitiés du chargeur. Il faut forcer un peu pour y arriver.

Une fois que vous avez séparé les deux pièces sur les quatre côtés, les deux moitiés restent accrochées. Elles sont collées sur tous les côtés du plastique.

Insérez le tournevis dans la partie haute du chargeur et séparez prudemment la feuille aluminium de la coque en plastique. Faites attention à ne pas arracher la feuille d'aluminium des entrailles du chargeur.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.