Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Inglese
Italiano

Traduzione in corso passo 10

Passo 10
Release the handle of the hand press, and remove the fabric. Inspect both sides of your snap to make sure that it is laying flat and tight up against the fabric.
  • Release the handle of the hand press, and remove the fabric.

  • Inspect both sides of your snap to make sure that it is laying flat and tight up against the fabric.

  • If the snap is not set all the way, reinsert the snap into the hand press, aligning it as it was before, and repeat step 9 of this guide.

Sollevare la leva del torchietto e togliere il tessuto.

Osservare entrambe le parti del bottone automatico per assicurarsi che sia montato ben piatto e fissato correttamente al tessuto.

Se il bottone automatico non è assemblato bene, posizionarlo nel torchietto come già fatto in precedenza, e ripetere il passaggio 9 della presente guida.

[* black] Release the handle of the hand press, and remove the fabric.
[* black] Inspect both sides of your snap to make sure that it is laying flat and tight up against the fabric.
[* icon_note] If the snap is not set all the way, reinsert the snap into the hand press, aligning it as it was before, and repeat [guide|16020|step 9|stepid=50155guide|19446|step 9|stepid=54518] of this guide.
[* icon_note] If the snap is not set all the way, reinsert the snap into the hand press, aligning it as it was before, and repeat [guide|16020|step 9|stepid=50155guide|19446|step 9|stepid=54518] of this guide.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.