Salta al contenuto principale

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 32le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 7

Passo 7
The front panel is attached with clips, and there are several ribbon cables connecting it to the rest of the phone. Your goal here is to release the clips and open the phone only enough to disconnect the cables. Go slowly and carefully to avoid damage.
Start lifting the front panel assembly
  • The front panel is attached with clips, and there are several ribbon cables connecting it to the rest of the phone. Your goal here is to release the clips and open the phone only enough to disconnect the cables. Go slowly and carefully to avoid damage.

  • Make sure the suction cup is firmly attached to the front panel assembly near the home button.

  • While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the home button end of the front panel from the rear case.

  • With a plastic opening tool, gently pry the edges of the rear case down, away from the front panel assembly, while you pull up with the suction cup.

  • Take your time and apply firm, constant force. The front panel assembly is a much tighter fit than on most other devices.

Das Frontpanel ist mit Clips festgemacht und es gibt mehrere Flachbandkabel, die es mit dem übrigen Telefon verbinden. Dein Ziel hier ist, die Clips zu lösen und das Telefon gerade so weit zu öffnen, um die Kabel lösen zu können. Gehe langsam und behutsam vor, um Schäden zu vermeiden.

Achte darauf, dass der Saugnapf knapp über dem Home Button fest auf der Display Einheit sitzt.

Während du das iPhone mit einer Hand unten hältst, ziehe an dem Saugnapf, um die Display Einheit auf der Home Button Seite etwas vom hinteren Gehäuse zu entfernen.

Heble mithilfe eines Plastik Opening Tools die Kanten des hinteren Gehäuses vorsichtig nach unten, weg von der Display Einheit, während du mit dem Saugnapf nach oben ziehst.

Nimm dir Zeit und übe einen konstant kräftigen Zug aus. Die Display Einheit ist bei diesen Geräten sehr fest eingepasst.

[title] Start lifting the front panel assembly
[* icon_caution] The front panel is attached with clips, and there are several ribbon cables connecting it to the rest of the phone. Your goal here is to release the clips and '''open the phone only enough to disconnect the cables'''. Go slowly and carefully to avoid damage.
[* icon_note] Make sure the suction cup is firmly attached to the front panel assembly near the home button.
[* black] While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the home button end of the front panel from the rear case.
[* black] With a plastic opening tool, gently pry the edges of the rear case down, away from the front panel assembly, while you pull up with the suction cup.
[* icon_caution] Take your time and apply firm, constant force. The 5s front panel assembly is a much tighter fit than on most other devices.
[* icon_caution] Take your time and apply firm, constant force. The 5s front panel assembly is a much tighter fit than on most other devices.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.