Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 6

Passo 6
Now it's time to remove the digital logic board. Remove the screw marked in red. The cable marked in blue (which I have already disconnected) and the cable marked in orange. Note: the cable in orange is oriented backwards from what you would expect based on where the cable goes. The yellow rectangle shows where the connector pins to the lower board are located. Remove the side panel by removing all four screws.
  • Now it's time to remove the digital logic board.

  • Remove the screw marked in red. The cable marked in blue (which I have already disconnected) and the cable marked in orange. Note: the cable in orange is oriented backwards from what you would expect based on where the cable goes. The yellow rectangle shows where the connector pins to the lower board are located.

  • Remove the side panel by removing all four screws.

  • Lastly, lift up on the logic board freeing it from the long pins that connect it to the main board.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.