Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Francese

Traduzione in corso passo 11

Passo 11
During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.
  • During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.

  • If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Utilisez l'extrémité plate d'un spudger pour clipser la partie avant de l'attache du câble du capteur d'empreintes sur le câble du connecteur.

Si l'attache ne s'enfonce pas bien, retirez-la et faites-la passer à nouveau par-dessus le câble du connecteur.

[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* icon_note] If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.