Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Spagnolo

Traduzione in corso passo 11

Passo 11
During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.
  • During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.

  • If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Utiliza la parte plana de un spudger para levantar la parte delantera del soporte del cable de Touch ID sobre el conector del cable.

Si el soporte no esta alineado cuando al cerrar, necesitaras quitar el soporte y deslizarlo sobre el conector de cable otra vez para un encaje mejor.

[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* icon_note] If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.