Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 11

Passo 11
During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.
  • During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.

  • If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Drücke die Vorderseite der Touch ID Abdeckung mit dem flachen Ende eines Spudgers nach unten über den Anschluss.

Wenn sich die Abdeckung nicht bündig abschließen lässt, musst du sie vielleicht entfernen und erneut über den Anschluss schieben.

[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* icon_note] If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.