Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Inglese
Italiano

Traduzione in corso passo 7

Passo 7
Perform the following steps once you have installed the new processors and ready to re-install the heatsinks.
Replacement Note: Existing Heatsink
  • Perform the following steps once you have installed the new processors and ready to re-install the heatsinks.

  • Preparing an EXISTING Heatsink for Re-installation. If you have a new heatsink, follow the NEW Heatsink procedure.

  • Using the alcohol pad included with the logic board or processor replacement part, clean off any used thermal grease from the processor and the bottom of the heatsink.

  • Using the thermal grease included with the logic board or processor replacement part, apply one dot of fresh grease to the raised square area on the bottom of the heatsink.

  • Spread the grease evenly across the square to a thickness of approximately 1 mm.

  • Warning: Do not apply more grease than recommended. The grease must not overflow the heatsink and come in contact with the processor connector.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.