Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 7

Passo 7
Make sure that the cable comes off the centre of the circuit board so the housing will fit over it.
  • Make sure that the cable comes off the centre of the circuit board so the housing will fit over it.

  • Also check that there is about 3mm of stripped cable on top of the circuit board as the strain relief has to fit here (see next photo)

  • Solder the other braid on the other side, in the opposite corner to the core. Try not to extend beyond the edge of the circuit board

  • Carefully file off any solder or cable that extends beyond the end of the circuit board.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.