Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 4

Passo 4
This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12. Disconnect the Bluetooth cable by pulling the male end straight away from its socket.
  • This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12.

  • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

  • Pull the connector parallel to the face of the logic board, not straight up.

  • Use the flat end of a spudger to pry the Bluetooth antenna cable up from its socket on the board.

この手順では、防眩ディスプレイが搭載されているモデルにのみ必要です。ノングレアタイプのディスプレイの方は手順12までスキップしてください。

Bluetoothケーブルのオスの先端をソケットからまっすぐ引き抜いて、接続を外します。

コネクタをロジックボードの表面に沿って並行に引き抜きます。上向きに引き上げないでください。

スパッジャーの平面側先端を使って、ボード上のソケットからBluetoothアンテナケーブルを持ち上げます。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.