Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 4

Passo 4
This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12. Disconnect the Bluetooth cable by pulling the male end straight away from its socket.
  • This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12.

  • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

  • Pull the connector parallel to the face of the logic board, not straight up.

  • Use the flat end of a spudger to pry the Bluetooth antenna cable up from its socket on the board.

Dieser Schritt ist nur für das entspiegelte Display nötig. Wenn du ein glänzendes Display hast, gehe gleich zu Schritt 12.

Ziehe das männliche Ende des Bluetooth-Kabels gerade aus seinem Anschluss heraus und trenne das Kabel ab.

Ziehe den Stecker parallel zur Oberfläche des Logic Boards, nicht senkrecht zu ihr.

Heble das Bluetooth-Antennenkabel mit dem flachen Ende des Spudgers aus seinem Anschluss auf der Platine.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.