Corsair One i145 M.2 NVME SSD Replacement

Torna alla Guida

Inglese

Italiano

Passo precedente Passo successivo

Traduzione in corso passo 3

Passo 3

Corsair One i145 M.2 NVME SSD Replacement, Remove Graphics Card Pwr Connector & Screws: passo 0, immagine 1 di 3

Corsair One i145 M.2 NVME SSD Replacement, Remove Graphics Card Pwr Connector & Screws: passo 0, immagine 2 di 3

Corsair One i145 M.2 NVME SSD Replacement, Remove Graphics Card Pwr Connector & Screws: passo 0, immagine 3 di 3

Remove Graphics Card Pwr Connector & Screws

Due to the limited space available A tool was required to help remove the power connectors. Using pliers to remove connectors that are usually removed by hand can damage your device if you are not careful. Proceed with caution.
Be careful NOT to rock the connector toward/away from you as that can break or bend the connections to the mainboard.
You might need to cut one more wire straps (white) to allow the power connectors to be removed from their housing or for the Graphics Card to be tilted out of the case. Be really careful not to cut any wires when removing the straps.
Use a spudger to slightly lift the connector hooks that are locking the power connectors in place and very carefully, use a 9in Needle-Nose Locking Pliers set to the lowest tension with enough grip to help you slowly and carefully rock the two power connectors gently up and down to pull the connectors out of their housings.
Remove the top and bottom screws that are holding the graphics card in-place

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.