Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 1

Passo 1
Use the flat end of a spudger to pry the fan cable connector up off its socket on the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.
  • Use the flat end of a spudger to pry the fan cable connector up off its socket on the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

スパッジャーの平面側先端を使って、ロジックボード上のソケットからファンケーブルコネクタを引き抜きます。

コネクタを解放するには、ファンケーブルのワイヤの下から垂直方向にスパッジャーをひねると上手く進みます。

ファンソケットとファンのコネクタは2、3番目の画像で確認できます。スパッジャーでファンコネクターをソケットからまっすぐ引き抜く作業では、ロジックボードからプラスチックファンのソケットを壊さないようにご注意ください。ロジックボードの配置は2番目の画像で確認できますが、お持ちのデバイスと若干異なる場合があります。ただし、ファン用のソケットは同一のはずです。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.