Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 5

Passo 5
When reassembling your device, attach the gasket to the heat sink as shown. The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.
  • When reassembling your device, attach the gasket to the heat sink as shown.

  • The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.

  • Be sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.

デバイスを再組み立てする際は、画像のようにヒートシンクにガスケットを装着してください。

ガスケットの先端はヒートシンクのくぼみにはめてください。ガスケットはロジックボードに付いているヒートシンクの下で切れないようにしてください。

ゴム製のガスケットにモールドされた小さなポストが、ロジックボードの右上隅にある穴と合わさるか確認してください。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.