Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 5

Passo 5
When reassembling your device, attach the gasket to the heat sink as shown. The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.
  • When reassembling your device, attach the gasket to the heat sink as shown.

  • The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.

  • Be sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.

Bringe beim Zusammenbau die Dichtung wie gezeigt am Kühlkörper an.

Das Ende der Dichtung muss in die Vertiefung am Kühlkörper passen, es sollte nicht unter der Lasche am Kühlkörper abschließen, die auf dem Logic Board aufliegt.

Achte darauf, dass die kleine eingeformte Noppe in der Gummidichtung in den Einschnitt in der oberen rechten Ecke des Logic Boards passt.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.