Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto sulla guida che include questo passo.

Inglese
Cinese

Traduzione in corso passo 12

Passo 12
Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.
  • Clean up the glue that remains on the borders. A small microfiber with a bit of WD40 or windex can help you take all the glue off.

  • Be sure to not use too much WD40 or windex.

  • When cleaning out the glue, do NOT attempt to scrap glue out of the cracks between the LCD and the frame. A very small amount of force toward the center or from underneath will crack the LED.

  • Cut up two small 1mm pieces of the sticker tape and glue the buttons to the phone to keep them in place.

  • It's very important to make sure the buttons line up exactly with the picture.

清理残留在边界上的胶水。有一点WD40或该小微纤维可以帮助你把所有的胶水清理掉。

不要使用太多的WD40或清洗剂。

清洗胶水时,不要试图将胶水从LCD和框架之间的缝隙中取出。一个向中心或下方的非常小的力将使LED产生裂纹。

剪下两块1毫米宽的胶带,然后将按键粘在手机上,使它们保持在适当的位置。

确保按钮和图片完全一致是很重要的。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.