Salta al contenuto principale

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte le 5guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 3

Passo 3
Use a Phillips screwdriver to remove the two 2 screws (circled in red) that are located on the back of the control port. Carefully separate the gray outer casing of the control port and the circuit board.
  • Use a Phillips screwdriver to remove the two 2 screws (circled in red) that are located on the back of the control port.

  • Carefully separate the gray outer casing of the control port and the circuit board.

Usa un cacciavite a croce Phillips per svitare le 2 viti (evidenziate in rosso) che si trovano sul retro delle prese dei controller.

Separa attentamente la copertura esterna grigia delle porte dei controller e della scheda logica.

-[* red] Use a Phillips screwdriver to remove the two 2 screws(circled in red) that are located on the back of the control port.
-[* black] Carefully separate the gray outer casing of the control port and the circuit board.
+[* red] Use a Phillips screwdriver to remove the two 2 screws (circled in red) that are located on the back of the control port.
+[* orange] Carefully separate the gray outer casing of the control port and the circuit board.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.