Turn the laptop so the back is facing you.

Using a #1 Phillips bit, remove the two (2) 6mm screws above the serial port and left side of the printer port.

Turn the laptop back around and open the screen. Using a #1 Phillips bit, remove the silver screw from the bottom left of the top hard drive case.

Remove the hard drive top enclosure by pulling back toward you and lifting up and out.

Carefully slide the hard drive to the right. This may take a little force so be carefull not to damage the capacitors on the right.

Once the drive is disconnected from the IDE connector, lift the right side up and remove. Set asside or replace.