Salta al contenuto principale

iMac Intel 27インチ Retina 5K Display 2020

Inglese
Giapponese

Traduzione in corso passo 12

Passo 12
iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 1 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 2 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 3 di 3
  • Place adhesive strip 25 on your work surface with the white side facing up and the opening of the microphone notch facing away from you.

  • Measuring from the center of the microphone notch, make two marks on the adhesive strip as guides for where to cut:

  • Make the first mark 13/16 inch (23 mm) right of the notch

  • Make the second mark 1 & 5/16 inch (29 mm) right of the notch

  • Rotate the adhesive strip so that the notch is now facing toward you.

  • Measuring from the bottom edge of the strip, make a third mark in between the first two 5/32 inch (4 mm) up from the bottom edge.

  • This cut will be very close to the top edge of the adhesive strip, but it's important that you leave material over top of the adhesive strip for proper sound isolation. When in doubt, remove less material than you think you need to. If the adhesive still covers the microphone you can always make the notch bigger.

白い面を上にして、マイクの切り欠きの開口部が手前になるように、接着ストリップ25を作業面に置いてください。

マイクの切り欠きの中心から測って、カットする場所の目安となる2つの印を接着ストリップに付けます。

最初のマークは切り欠きの右23mmにつけます。

2つ目のマークは、切り欠きの右側に29mmの位置に付けます。

接着剤ストリップを回してさせ、切り欠きを手前に配置します。

ストリップの下端から測って、最初の2つのマークの間に、下端から5/32インチ(4mm)上がったところに3つ目のマークを付けます。

このカットは、接着ストリップ上端に非常に近い場所ですが、適切な遮音のためには、接着ストリップの上にマテリアルを残すことが重要です。迷った場合は、必要と思われる量よりも少ない量の材料を取り除くようにしてください。接着剤がまだマイクを覆っている場合は、切り欠きを大きくすることができます。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.