Salta al contenuto principale

Reemplazo del adhesivo de pantalla del iMac Intel 27"Pantalla Retina 5K 2020

Inglese
Spagnolo

Traduzione in corso passo 12

Passo 12
iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 1 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 2 di 3 iMac Intel 27" Retina 5K Display 2020 Display Adhesive Replacement: passo 0, immagine 3 di 3
  • Place adhesive strip 25 on your work surface with the white side facing up and the opening of the microphone notch facing away from you.

  • Measuring from the center of the microphone notch, make two marks on the adhesive strip as guides for where to cut:

  • Make the first mark 13/16 inch (23 mm) right of the notch

  • Make the second mark 1 & 5/16 inch (29 mm) right of the notch

  • Rotate the adhesive strip so that the notch is now facing toward you.

  • Measuring from the bottom edge of the strip, make a third mark in between the first two 5/32 inch (4 mm) up from the bottom edge.

  • This cut will be very close to the top edge of the adhesive strip, but it's important that you leave material over top of the adhesive strip for proper sound isolation. When in doubt, remove less material than you think you need to. If the adhesive still covers the microphone you can always make the notch bigger.

Coloca la tira adhesiva 25 sobre su superficie de trabajo con la cara blanca hacia arriba y la abertura de la muesca del micrófono en dirección contraria a usted.

Midiendo desde el centro de la muesca del micrófono, haz dos marcas en la tira adhesiva como guías para saber dónde cortar:

Haz la primera marca a 23 mm a la derecha de la muesca.

Haga la segunda marca a 29 mm a la derecha de la muesca.

Gire la tira adhesiva de modo que la muesca quede orientada hacia usted.

Midiendo desde el borde inferior de la tira, haga una tercera marca entre las dos primeras a 4 mm (5/32 pulgadas) del borde inferior.

Este corte estará muy cerca del borde superior de la banda adhesiva, pero es importante que dejes material por encima de la banda adhesiva para conseguir un aislamiento acústico adecuado. En caso de duda, retira menos material del que creas necesario. Si el adhesivo sigue cubriendo el micrófono, siempre puedes hacer la muesca más grande.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.