Aggiusta le tue cose Community Store

iPad 4 CDMAのロジックボードコネクタの交換

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Giapponese

Traduzione in corso passo 1

Passo 1
iPad 4 CDMA Logic Board Connectors Replacement: passo 0, immagine 1 di 1

  • Disconnect the following connectors from their respective sockets on the logic board:

  • Wi-Fi antenna cable

  • Speaker connector cable.

  • Dock/Lightning connector cable.

  • There may be a piece of black tape covering this connector. Remove it with tweezers.

  • Make sure to pry underneath the connector and not the socket itself. Prying on the socket itself may cause severe damage.

ロジックボード上の各ソケットから次のコネクタの接続を外します:

Wi-Fiアンテナケーブル

スピーカーコネクタケーブル

ドック/Lightningコネクタケーブル

このコネクタを覆っている黒のテープがあります。ピンセットを使って、テープを剥がします。

ソケットではなく、コネクタの下から持ち上げているか確認してください。ソケットを持ち上げると、深刻なダメージを引き起こす可能性があります。

[* black] Disconnect the following connectors from their respective sockets on the logic board:
[* red] Wi-Fi antenna cable
[* orange] Speaker connector cable.
[* yellow] Dock/Lightning connector cable.
- [* icon_note] There may be a piece of black tape covering this connector. Remove it with tweezers.
+ [* icon_note] There may be a piece of black tape covering this connector. Remove it with [product|IF145-020|tweezers].
[* icon_caution] Make sure to pry underneath the connector and not the socket itself. Prying on the socket itself may cause severe damage.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.