Salta al contenuto principale

Sostituzione staffa fotocamera iPad 2 CDMA

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 9le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 1

Passo 1
iPad 2 CDMA Camera Bracket Replacement: passo 0, immagine 1 di 1
  • The camera bracket is attached to the front panel by adhesive. The use of an iOpener to soften the adhesive is highly recommended.

  • Follow the iOpener heating instructions described in the iOpener heating section at the beginning of this guide.

  • Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.

  • Place the iOpener over the front facing camera on the front edge of the top of the display.

La staffa della fotocamera è attaccata al pannello anteriore con dell'adesivo. L'uso di un iOpener per ammorbidire l'adesivo è fortemente consigliato.

Segui le istruzioni per scaldare l'iOpener come descritto nella sezione sul riscaldamento dell'iOpener all'inizio di questa guida.

Stai attento a non surriscaldare l'iOpener durante la riparazione. Ti consigliamo di aspettare almeno due minuti prima di scaldare di nuovo l'iOpener.

Appoggia l'iOpener sopra la fotocamera anteriore sul margine anteriore dello schermo.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.