Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 9

Passo 9
Apply a suction cup to the back of the phone, as close to the center of the right edge as possible. Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame. Insert the point of an opening pick into the gap.
Separate the right edge adhesive
  • Apply a suction cup to the back of the phone, as close to the center of the right edge as possible.

  • Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.

  • Insert the point of an opening pick into the gap.

  • Like with the previous edge, you will need to tilt the opening pick downward to fully insert it underneath the back cover.

Setze einen Saugheber auf die Rückseite des Smartphones, und zwar so mittig auf die rechte Kante wie möglich.

Ziehe gleichmäßig und fest am Saugheber, um einen Spalt zwischen Rückabdeckung und Rahmen zu erzeugen.

Setze die Spitze eines Plektrums in den Spalt ein.

Genauso wie bei der vorhergehenden Kante, musst du das Plektrum nach unten kippen, um es ganz unter die Rückabdeckung zu schieben.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.