Aggiusta le tue cose Community Store

Retrait de la coque arrière

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Francese
Passo precedente

Traduzione in corso passo 11

Passo 11
Back Cover Removal: passo 0, immagine 1 di 1

  • Remove the back cover.

  • To re-install the back cover:

  • Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive. You don't have to clear out adhesive down to the plastic but larger pieces should be removed.

  • Turn on your phone and test your repair before installing new adhesive and resealing the phone.

  • Carefully apply the new adhesive to the back cover, then line up one edge of the glass against the phone chassis and firmly press the glass into the phone.

Ôtez la coque arrière.

Pour la remonter :

Décollez les résidus d'adhésif du châssis du téléphone avec une pincette. Puis nettoyez les zones d'adhérence avec de l'alcool isopropylique à haute concentration (au moins 90 %) et un chiffon non pelucheux afin de préparer la surface pour le nouvel adhésif.

Allumez votre téléphone et testez votre réparation avant d’installer un nouvel adhésif et de refermer le téléphone.

Appliquez soigneusement l'adhésif sur la coque arrière, puis alignez un bord de la vitre contre le châssis du téléphone et appuyez fermement dessus pour les encastrer.

Vous pouvez également réinstaller la coque arrière sans remplacer l'adhésif. Enlevez les gros morceaux d'adhésif qui pourraient empêcher la coque d'adhérer correctement. Après le remontage, chauffez la coque et appuyez dessus pour qu'elle adhère. Ce ne sera pas étanche, mais la colle devrait suffire pour maintenir le tout en place.

[* black] Remove the back cover.
-[* icon_reminder] To install a back cover:
- [* black] Use tweezers to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive.
+[* icon_reminder] To re-install the back cover:
+ [* black] Use [product|IF145-020|tweezers] to peel away any remaining adhesive from the phone's chassis. Then clean the adhesion areas with high concentration isopropyl alcohol (at least 90%) and a lint-free cloth to prep the surface for the new adhesive. You don't have to clear out adhesive down to the plastic but larger pieces should be removed.
[* black] Turn on your phone and test your repair before installing new adhesive and resealing the phone.
[* black] Carefully apply the new adhesive to the back cover, then line up one edge of the glass against the phone chassis and firmly press the glass into the phone.
- [* icon_note] Alternatively, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.