Aggiusta le tue cose Community Store

后盖移除

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Cinese
Passo precedente Passo successivo

Traduzione in corso passo 7

Passo 7
Back Cover Removal: passo 0, immagine 1 di 3 Back Cover Removal: passo 0, immagine 2 di 3 Back Cover Removal: passo 0, immagine 3 di 3

  • Be careful near the corners, as the glass is weakest there.

  • Insert an opening pick into the lower-left corner of the rear panel.

  • Using another opening pick, cut the adhesive along the left edge of the rear panel.

  • Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.

  • It is fine if opening picks fall out as the back cover becomes separated.

在后面板的左下角插入一个三角撬片。

使用另一个三角撬片，沿着后面板的左边缘切开粘合剂。

请勿在指纹传感器附近的左边缘插入超过一半的三角撬片，否则可能损坏内部的带状电缆。

如果后盖分离，则三角撬片掉下来也是可以的。

+[* icon_caution] Be careful near the corners, as the glass is weakest there.
[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.