Aggiusta le tue cose Community Store

バックカバーの取り外し

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Torna alla Guida
Inglese
Giapponese
Passo precedente Passo successivo

Traduzione in corso passo 7

Passo 7
Back Cover Removal: passo 0, immagine 1 di 3 Back Cover Removal: passo 0, immagine 2 di 3 Back Cover Removal: passo 0, immagine 3 di 3

  • Be careful near the corners, as the glass is weakest there.

  • Insert an opening pick into the lower-left corner of the rear panel.

  • Using another opening pick, cut the adhesive along the left edge of the rear panel.

  • Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.

  • It is fine if opening picks fall out as the back cover becomes separated.

オープニングピックを背面パネルの左下隅に差し込みます。

別のオープニングピックを使って、背面パネルの左端に沿って粘着剤を切ります。

指紋センサー付近の左端に半分以上オープニングピックを差し込むと、内部のリボンケーブルが破損することがあります。

背面カバーが分離する際に、オープニングピックが落ちてもかまいません。

+[* icon_caution] Be careful near the corners, as the glass is weakest there.
[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.