Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Giapponese

Traduzione in corso passo 20

Passo 20
At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips. If you've already verified that your iMac is working correctly and are ready to seal it up, skip to step 22. Gently insert the display data connector into its socket on the logic board. Be sure to press it straight into the socket, and insert it completely.
Test your repair
  • At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.

  • If you've already verified that your iMac is working correctly and are ready to seal it up, skip to step 22.

  • Gently insert the display data connector into its socket on the logic board. Be sure to press it straight into the socket, and insert it completely.

  • Flip the display data connector lock down onto the socket.

  • Insert the display power connector into its socket on the logic board.

この時点で、修理の状況をテストして、iMacが正しく起動することを確認してから再組み立てすることをお勧めします。 接着ストリップの裏地を剥がす前に、次の3つの手順に従って、ディスプレイケーブルを一時的に再接続し、iMacを起動します。

iMacが正しく動作していることを確認し、密封する準備ができている場合は、手順22に進んでください。

ディスプレイデータコネクタをロジックボードのソケットに挿入します。 ソケットに真っ直ぐ押し込み、しっかり奥まで差し込みます。

ディスプレイデータコネクタのロックをソケット上に下ろします。

ディスプレイの電源コネクタをロジックボードのソケットに挿入します。

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.