Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Cinese

Traduzione in corso passo 3

Passo 3
Before you install new adhesive strips, remove all of the old adhesive from the perimeter of the rear enclosure. If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
Remove the old adhesive
  • Before you install new adhesive strips, remove all of the old adhesive from the perimeter of the rear enclosure.

  • If you are re-using your existing display, you must also remove the old adhesive from the back of the display.

  • Peel off the adhesive strips using tweezers or your fingers. Start at the bottom and peel upward towards the top of the device.

  • After all the old adhesive is removed, carefully clean the surface with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.

  • Don't skip this step, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.