Salta al contenuto principale

Rimozione cover posteriore Samsung Galaxy S20 Ultra

Nota: Stai modificando un prerequisito per la guida che stavi visualizzando. Tutte le modifiche avranno effetto su tutte 17le guide che includono questo passo.

Inglese
Italiano

Traduzione in corso passo 5

Passo 5
Samsung Galaxy S20 Ultra Back Cover Removal, Separate the left edge adhesive: passo 0, immagine 1 di 3 Samsung Galaxy S20 Ultra Back Cover Removal, Separate the left edge adhesive: passo 0, immagine 2 di 3 Samsung Galaxy S20 Ultra Back Cover Removal, Separate the left edge adhesive: passo 0, immagine 3 di 3
Separate the left edge adhesive
  • Apply a suction cup to the back of the phone, as close to the center of the left edge as possible.

  • Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.

  • Insert the point of an opening pick into the gap.

  • As the glass on this edge is curved, you won't be able to insert this pick very far. As long as the very tip of the pick is underneath the glass's edge, you will be able to proceed.

  • Due to tight tolerances, this may take multiple attempts.

  • If you are having trouble creating a gap, apply more heat to the edge and try again.

  • You can try also applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.

  • Do not apply excessive force with the pick, or you risk cracking the back cover glass.

Fai aderire una ventosa al vetro posteriore, il più vicino possibile al centro del bordo sinistro.

Tira la ventosa con forza elevata e costante per creare una fessura tra il vetro posteriore e la cornice.

Infila la punta di un plettro nella fessura.

Poiché il vetro è curvo su questo bordo, non riuscirai ad infilare molto il plettro. Finché anche solo la punta del plettro è sotto il bordo del vetro, riuscirai a procedere.

A causa delle strette tolleranze, questo passaggio può richiedere più tentativi.

Se stai avendo problemi nel creare la fessura, scalda ulteriormente il bordo e riprova.

Puoi anche provare ad applicare qualche goccia di alcool isopropilico ad alta concentrazione (>90%) nella fessura per ammorbidire l'adesivo.

Non fare troppa forza con il plettro, o rischi di rompere il vetro posteriore.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.