Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Spagnolo

Traduzione in corso passo 4

Passo 4
Repeat the previous two steps to remove the three adhesive strips on the other side of the battery. If any of the adhesive strips broke, you can use high-concentration (>90%) isopropyl alcohol to help remove them: Carefully drip isopropyl alcohol along either edge of the battery, in the recessed part of the upper case, where the adhesive pull tabs were.
  • Repeat the previous two steps to remove the three adhesive strips on the other side of the battery.

  • If any of the adhesive strips broke, you can use high-concentration (>90%) isopropyl alcohol to help remove them:

  • Carefully drip isopropyl alcohol along either edge of the battery, in the recessed part of the upper case, where the adhesive pull tabs were.

  • Applying too much alcohol or applying it outside of the wells in the case where the adhesive sits risks damaging other components.

  • Let the alcohol soak into the adhesive for a minute or two.

  • Use opening picks to gently pry the battery away from the upper case.

Repite los dos pasos anteriores para quitar las tres tiras adhesivas del otro lado de la batería.

Si alguna de las tiras adhesivas se rompió, puede usar alcohol isopropílico de alta concentración (>90%) para ayudar a quitarlas:

Cuidadosamente gotea alcohol isopropílico a lo largo de cada borde de la batería, en la parte empotrada de la caja superior, donde estaban las tiras adhesivas.

Aplicar demasiado alcohol o aplicarlo fuera de los pozos en la caja donde se encuentra el adhesivo corre el riesgo de dañar otros componentes.

Deja que el alcohol se empape en el adhesivo durante uno o dos minutos.

Usa las púas de apertura para apartar suavemente la batería de la caja superior.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.