Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Spagnolo

Traduzione in corso passo 3

Passo 3
Use tweezers to lift the adhesive pull tab at the top of the left speaker enough that you can grab it with your fingers. Grab the adhesive strip pull tab and slowly and carefully pull the adhesive strip out from under the speaker. Keep the angle of the adhesive strip as parallel to the laptop as you can. Try to avoid dragging it across the inside of the case.
  • Use tweezers to lift the adhesive pull tab at the top of the left speaker enough that you can grab it with your fingers.

  • Grab the adhesive strip pull tab and slowly and carefully pull the adhesive strip out from under the speaker.

  • Keep the angle of the adhesive strip as parallel to the laptop as you can. Try to avoid dragging it across the inside of the case.

  • If the adhesive strip breaks, or if the first adhesive strip broke, use a heated iOpener or heat gun to help remove the adhesive:

  • Apply heat to the speaker to soften the adhesive underneath.

  • Carefully slide a spudger or opening pick underneath the speaker to separate the adhesive.

Usa pinzas para levantar la lengüeta adhesiva en la parte superior del altavoz izquierdo lo suficiente como para que puedas agarrarla con los dedos.

Agarra la lengüeta de la tira adhesiva y tira lenta y cautelosamente la tira adhesiva de debajo del altavoz.

Mantén el ángulo de la tira adhesiva lo más paralelo posible al portátil. Trata de evitar arrastrarla por el interior de la caja.

Si la tira adhesiva se rompe, o si se rompe la primera tira adhesiva, usa un iOpener caliente o una pistola de calor para ayudar a quitar el adhesivo:

Aplica calor al altavoz para ablandar el adhesivo de debajo.

Desliza con cuidado un spudger o una púa de apertura debajo del altavoz para separar el adhesivo.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.