Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Inglese
Italiano

Traduzione in corso passo 4

Passo 4
Start with level 6 diamond paste You will apply about a dime size of paste, then using your finger to spread the paste evenly around the watch face. After spreading out the diamond paste, turn your Dremel on its lowest speed and apply the felt tip to the watch face.
  • Start with level 6 diamond paste

  • You will apply about a dime size of paste, then using your finger to spread the paste evenly around the watch face.

  • After spreading out the diamond paste, turn your Dremel on its lowest speed and apply the felt tip to the watch face.

  • IMPORTANT: rotate the Dremel in circular motions as you work around the sapphire. DO NOT press to hard or Dremel too long on a specific area, it could crack your face.

  • Take little 20 second breaks allowing the face to cool down, if it over heats it could be many problems.

  • You will repeat the same steps above for each grade of diamond paste.

  • Apply a little more pressure on the really scratched area to get better results.

  • NOTE* when you press harder on specific areas using your Dremel make sure your not overheating the crystal, it can heat up in a matter of 5 seconds. Touch the area scratched often to ensure its cool.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.