Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Spagnolo

Traduzione in corso passo 1

Passo 1
Use a pair of tweezers to lift up the black adhesive pull tab at the bottom of the right speaker, enough so you can grab it with your fingers. Grab the adhesive strip pull tab and slowly and carefully pull the adhesive strip out from under the speaker. Keep the angle of the adhesive strip as parallel to the laptop as you can. Try to avoid dragging it across the inside of the case.
Remove the right speaker adhesive
  • Use a pair of tweezers to lift up the black adhesive pull tab at the bottom of the right speaker, enough so you can grab it with your fingers.

  • Grab the adhesive strip pull tab and slowly and carefully pull the adhesive strip out from under the speaker.

  • Keep the angle of the adhesive strip as parallel to the laptop as you can. Try to avoid dragging it across the inside of the case.

  • If the adhesive strip breaks, leave it in and proceed to the next step.

Usa un par de pinzas para levantar la lengüeta adhesiva negra de la parte inferior del altavoz derecho, lo suficiente para que puedas agarrarla con los dedos.

Agarra la lengüeta de la tira adhesiva y tira lenta y cautelosamente la tira adhesiva de debajo del altavoz.

Mantén el ángulo de la tira adhesiva lo más paralelo posible al portátil. Trata de no arrastrarla por el interior de la caja.

Si la tira adhesiva se rompe, déjala dentro y procede al siguiente paso.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.