Salta al contenuto principale
Inglese
Giapponese

Traduzione in corso passo 2

Passo 2
The first one we to do is apply the specialized glue remover XII to the gap between the bezel and the OLED. Then we scrape the cold glue in the bottom of the bezel’s flex cable position with a plastic slice. Once done, we cut the bracket around the bang with a cut pliers.                         Next, we start to take apart the bezel.
Bezel Removing-A Part
  • The first one we to do is apply the specialized glue remover XII to the gap between the bezel and the OLED.

  • Then we scrape the cold glue in the bottom of the bezel’s flex cable position with a plastic slice.

  • Once done, we cut the bracket around the bang with a cut pliers. Next, we start to take apart the bezel.

  • For this part, there are two tips we need to be cautioned. One is pay attention to your strength while you remove the bracket. When pulling the bracket out, pressing it down would be more appropriate.

  • The other is that if the bracket is hard for you to remove, you can apply some XII glue remover on the plastic slice and insert it into the gap to scrape inner cold glue. But can’t apply too much glue remover on the flex cable and IC position.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.