Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 2

Passo 2
If the voltage is below about 2.75 volts, the battery will have to be removed.  Using a soldering iron, melt the solder holding one of the solder tabs to the board.  While the solder is molten, pull the solder tab away from the board with a pair of tweezers. Repeat the procedure for the other solder tab. The battery is held to the board with a piece of double sided fabric tape.  This will probably rip apart when you pull the battery off.
  • If the voltage is below about 2.75 volts, the battery will have to be removed. Using a soldering iron, melt the solder holding one of the solder tabs to the board. While the solder is molten, pull the solder tab away from the board with a pair of tweezers.

  • Repeat the procedure for the other solder tab.

  • The battery is held to the board with a piece of double sided fabric tape. This will probably rip apart when you pull the battery off.

  • It would be a good idea to put shrink tubing around the new battery to ensure it doesn't short out to anything on the control board.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.