Salta al contenuto principale

iPod Touch 7e generatie Vervanging van het voorste paneel

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Olandese

Traduzione in corso passo 4

Passo 4
iPod Touch 7th Generation Front Panel Replacement: passo 0, immagine 1 di 3 iPod Touch 7th Generation Front Panel Replacement: passo 0, immagine 2 di 3 iPod Touch 7th Generation Front Panel Replacement: passo 0, immagine 3 di 3
  • Hold the iPod firmly against a table or bench.

  • Place your thumb and index finger over the lower corners of the display to stop the display from opening too far when the adhesive breaks.

  • Lift the suction cup up and back toward the top of the iPod. Be patient, and pull with firm, constant force until the adhesive breaks and the display comes up from the rear case.

  • It may be necessary to use a heat gun to soften the adhesive (especially in cooler climates). If you can pry the screen apart, and the adhesive is still sticking and pulling apart like cheese topping on a pizza, you can slide a thin razor blade in and gently cut the adhesive.

  • After the display begins to lift from the rear case, be careful not to lift more than about an inch—a fragile plastic frame still connects the display assembly to the rear case.

Houd de iPod stevig op een tafel vast.

Plaats je duim en wijsvinger over de onderste hoeken van het scherm om te voorkomen dat het scherm te ver open bij het breken van de lijm.

Til de zuignap op en beweeg deze richting de bovenkant van de iPod. Wees geduldig en trek met een stevige, constante kracht totdat de lijm breekt en het scherm van de achterste behuizing los komt.

Het kan nodig zin om een warmtepistool te gebruiken om de lijm voldoende te verzachten (helemaal in koudere gebieden). Als je het scherm los weet te krijgen, maar de lijm blijft nog steeds vastzitten, kun je een mesje gebruiken om de lijm door te snijden.

Til het scherm, nadat deze los en omhoog komt van de achterste behuizing, niet verder omhoog dan ongeveer 2.5 cm (1 inch)—er is een kwetsbaar plasticen frame dat de schermmodule nog steeds met de achterste behuizing verbindt.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.