Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 7

Passo 7
Slide the pick all along the top edge of the phone to slice through the adhesive securing the rear glass. Take care to not insert the pick more than ~1 cm past the edge of the glass to avoid damaging the thermal dissipation pad surrounding the camera bump. Slow down and slice very carefully as you get to the corners. The curved part of the glass along the left and right edges can crack very easily if the pick pushes up against the curved glass.
  • Slide the pick all along the top edge of the phone to slice through the adhesive securing the rear glass.

  • Take care to not insert the pick more than ~1 cm past the edge of the glass to avoid damaging the thermal dissipation pad surrounding the camera bump.

  • Slow down and slice very carefully as you get to the corners. The curved part of the glass along the left and right edges can crack very easily if the pick pushes up against the curved glass.

  • Leave the pick under the top left corner of the glass to prevent the adhesive from re-adhering. Continue with a new pick.

Schiebe das Plektrum entlang der oberen Kante des Handys zum Trennen des Klebers, welcher die Glas-Rückabdeckung sichert.

Achte darauf, dass du das Plektrum nicht tiefer als etwa 1 cm unter die Kante des Telefons schiebst, damit das Wärmeableitungskissen um die Kameraeinheit nicht beschädigt wird.

Führe das Plektrum langsam und vorsichtig um die Ecken des Handys. Der gebogene Teil des Glases am linken und rechten Rand kann sehr leicht springen, wenn das Pick dagegen drückt.

Lasse das Plektrum in der oberen linken Ecke stecken, um ein Wiederverkleben zu verhindern und führe die nächsten Schritte mit einem anderen Plektrum durch.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.