Salta al contenuto principale

Repairing a Kenwood Chef A901D That Emits a Burning Smell

Tedesco
Inglese

Traduzione in corso passo 13

Passo 13
Kenwood Chef Motorelektronik reparieren: passo 0, immagine 1 di 1
  • So wird der Geschwindigkeitsregler eingestellt:

  • Drehe die beiden Regulierschrauben soweit ein, bis du sie mit dem Finger gerade auf der Rückseite spüren kannst. Drehe dann zwei Umdrehungen weiter.

  • Stelle den Regelknopf auf minimale Drehzahl.

  • Achtung: Netzspannung - nicht hineingreifen!

  • Schließe den Netzstecker an.

  • Die Maschine sollte langsam laufen. Die richtige Einstellung ist 60 Umdrehungen des großen Antriebs in der Minute.

  • Reguliere die Drehzahl indem du beide Regulierschrauben gleichmäßig verdrehst.

  • Jetzt kannst du das Netzkabel abtrennen und das Gerät endgültig zusammenbauen, folge den Schritten in umgekehrter Reihenfolge.

Adjusting of the speed control after repair:

Turn both adjustment screws only until you can feel them flush with your fingertips on the rear side of the screw holes. Then turn the screws two turns more.

Set the speed adjuster to the lowest setting.

Attention: high voltage, don't reach with your fingers into the motor.

Plug in.

The motor should run slowly. The correct speed for the planetary drive ist 60 rpm.

Adjust the speed by turning the adjustment screws evenly.

Remove the power cord and reassemble your device following the steps in reverse order.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.