Salta al contenuto principale
Inglese
Italiano

Traduzione in corso passo 1

Passo 1
Use the Phillips #1 screwdriver to remove the two 3.1mm screws from the LED PCB. Lift the LED PCB up with your fingers and flip it over revealing the ZIF connector. The LED PCB is still tethered to the daughterboard via a ribbon cable so be sure not to yank it out or it could cause damage to the cable or its connectors.
  • Use the Phillips #1 screwdriver to remove the two 3.1mm screws from the LED PCB.

  • Lift the LED PCB up with your fingers and flip it over revealing the ZIF connector.

  • The LED PCB is still tethered to the daughterboard via a ribbon cable so be sure not to yank it out or it could cause damage to the cable or its connectors.

Inserisci qui la traduzione

Inserisci qui la traduzione

Inserisci qui la traduzione

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.