Salta al contenuto principale

Avviso: Stai modificando una guida prerequisita. Tutte le modifiche avranno effetto su tutte le guide che includono questo passo.

Inglese
Tedesco

Traduzione in corso passo 1

Passo 1
Insert the flat end of a spudger underneath the battery connector, which is attached to the motherboard below the rear-facing camera. Pry upwards to disconnect the connector from its socket. When you disconnect connectors like these, be careful not to dislodge the small surface-mounted components surrounding the socket.
Disconnect the battery
  • Insert the flat end of a spudger underneath the battery connector, which is attached to the motherboard below the rear-facing camera.

  • Pry upwards to disconnect the connector from its socket.

  • When you disconnect connectors like these, be careful not to dislodge the small surface-mounted components surrounding the socket.

  • Gently push the battery's flex cable away from the motherboard socket to prevent accidental contact.

Setze das flache Ende eines Spudgers unter den Akkustecker, der unterhalb der Rückkamera am Motherboard befestigt ist.

Heble nach oben, um den Stecker aus seinem Anschluss zu lösen.

Wenn du Stecker wie diesen hier trennst, musst du darauf achten, dass du dabei nicht versehentlich die kleinen Komponenten, die sich um den Anschluss herum befinden, beschädigst.

Schiebe das Flachbandkabel des Akkus vorsichtig von seinem Motherboard-Anschluss weg, damit es sich nicht versehentlich wieder verbindet.

I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.